Product DescriptionSABRENT SATA-ES2P 2-PORT BRACKET. EXTENDS SATA CAPACITY FROM AN INTERNAL SATA PO
Customer Reviews
Average Rating:
Rating: - Works fine, cables may be too short for some computers
Well-made, installed easily, works fine. The connectors are strong, so the problem someone else reported may have been fixed. The cables are a little over 9 inches long. That's longer than the 6.3 inches the description claims, and were (just) long enough to reach the SATA ports on my computer's Motherboard.
If the case was any larger, or if I hadn't been able to put the bracket in the bottommost slot, the cables would not have been long enough. Since an extra few inches wouldn't ... Read More
Rating: - Does The Job, It's Just a Bulkhead
I found this eSATA bulkhead exactly as advertised, and inexpensive.
The metal bracket is the same as every PC interface card. The internal cables could be a tiny bit longer, so measure carefully inside your case before you purchase (they fit my case perfectly - a full size Intel ATX motherboard).
The eSATA socket is no different than all the others I've seen. Remember these are not USB connectors. Fundamentally the eSATA connector is a bad design, not the fault of this product. ... Read More
Rating: - Zero stars
Amazon doesn't accept a zero star rating, but that's all this product gets. The idea behind this product is good, but it's made so el-cheapo it's almost unusable.
I found the cables long enough, although barely. They are 9 inches long. (That's 22.5 cm, more than the 16m on the product descriptor.)
The real problem with this product is the external connector. It's barely usable. The connector has two small latches that are meant to lock the cable into place. They seem to be made out ... Read More
Rating: - Very Bad Product - eSata Connectors to case
This is a very very very bad product. The 2 eSata leads that connect to the motherboard are too short. Even when I rearranged the other PCI adapters, I was still not able to connect both eSata leads to the motherboard. Very stupid design. Leads should be at least 4 inches longer.